Technical FAQs

Ask a Question

How to configure variable speed drive ATV312 speed controller to start automatically after a power failure?

This can be done by setting Automatic restart parameter to Yes.
Note: This function will only be active in 2-wire level control
& it permits the drive to restart if the fault has been cleared and the other operating conditions permit the restart. The restart is performed by a series of automatic attempts
[Mot. phase] (OPF): Motor phase loss
[Mains overvoltage] (OSF): Line supply overvoltage
[Mains phase loss] (PHF): Line phase loss
Please check the attached page from the manual with all the conditions for using this functionality.
Was this helpful?
What can we do to improve the information ?